YANMAR GA52 Used Motor Boats for Sale in Japan

Exterior
Overall length: 16.5 m, width: 3.7 m (wide-body). A solid, rock-solid hull that doesn’t budge an inch. It was reportedly used primarily for fishing for young sardines and flounder.
Hull Bottom/Propeller/Rudder

Front Deck
A solid deck equipped with a three-stage hydraulic roller system. There are 9 livewells and 2 air-filled compartments. It is said to hold up to 3,000 kg of pufferfish.
Bridge
Apparently, an awning was not installed to avoid exceeding the tonnage limit. It is currently registered at 8.5 tons. The bridge is 4.7 m long and 1.7 m wide.The side deck is 80 cm wide. The height is 70 cm. The windows at the front and on both sides are made of tempered glass, not acrylic. The rotating windows operate properly. The bilge pump and rollers operate properly. The private toilet is mostly used for storage. There is a toilet seat, but it is not in use.
Cockpit
It is equipped with nearly all the professional-grade instruments needed for operation, including a fish finder, chartplotter, radar, autopilot, triple remote control, and a bilge pump. The space under the floor is a spacious compartment where the batteries are housed.
Cabin

Aft Deck
The deck is solid and sturdy. To facilitate work, unnecessary fittings have been omitted, and the bulwark has been kept straight and flat to prevent nets from snagging. There are two insulated ice compartments here, each with an inner lid. The hatches are lightweight yet sturdy. The steering cylinder is also in good condition. A 200L fresh water tank is installed.
Yanmar 6KY-ET, max 630 hp, 9 kW generator
Since the vessel was in operation until recently, there are no major issues, but for peace of mind, it is recommended to replace the oil, impeller, and filters before setting sail.